How to take the unit out of service for a short stop, for storage or for return to HydroXpand.
- OrderHXB-V1 first, then dryer
How to read this chapter
First timeFollow the steps in order.
Done this beforeGo to storage after use.
On this pageShutting down
Shutting down#
- Stop hydrogen production at the HXB-V1 units.
- Let the dryer depressurise through its vents. Confirm on the control PC that the outlet pressure reads zero.
- Switch off at ON/OFF and remove the power cord.
- Disconnect the tubing and cap every gas port straight away.
Storage after use#
- Store as described in the Receiving and storage chapter: indoors, dry, frost-free and with all ports capped.
- Before restarting after a long stop, expect one or more full regeneration cycles before the outlet reaches its dew point.
Return and disposal#
Contact HydroXpand before returning a unit. The adsorbent and the electronics are disposed of separately; we take the unit back for this.
What this chapter is based on
- HXD-V1 datasheetPDF · 3.2 MB
- HXD-V1 outline drawingPDF · 368 KB
- First start checklistPDF · 61 KB
- Routine check sheetPDF · 66 KB
- Maintenance logPDF · 49 KB
- HXD-V1 user manualPDF · 2.7 MB
Was this page helpful?
Thank you. We read every answer.
Tell us what was missing and we will fix this page. Tell us what was missing →
Ask the engineer who built it
If your case is not covered here, send us the operating condition and what you observed. The engineer who designed the system answers directly.